[villain]

Irritatingly every time my Tangara breaks it manages to do it in a new way    as title, when turned on my Tangara is hanging on the logo screen, and won't turn off until power runs out. I was having this issue on firmware v1.3.1, I used the CLI to flash v2.0.0 and I'm having the same problem still.

[ailurux]

Irritatingly every time my Tangara breaks it manages to do it in a new way    as title, when turned on my Tangara is hanging on the logo screen, and won't turn off until power runs out. I was having this issue on firmware v1.3.1, I used the CLI to flash v2.0.0 and I'm having the same problem still.

Oh, that's very odd. Have you tried without an SD card inserted, in case that's causing the issue? The best way to debug this would be to get the serial output to see if any errors are logged: https://cooltech.zone/tangara/docs/developer/debugging/

If you can use `idf.py monitor` it should also reset the Tangara so you won't need to wait for the power to run out, but if you don't have that set up you can use any serial console to get the logging, though you'll want to be logging when it starts up to see what errors are logged at the point where it hangs.