(2025-06-19, 03:07 AM)jacqueline Wrote: We added dedicated footprints for this in our production runs; R3 and R8 are the ones you want to replace or solder over. We used an 0805 footprint so they'd be a little easier for folks to work with. Susumu RR-series resistors are a good pick, here's a digikey search for the relevant range: https://www.digikey.com.au/en/products/f...GTB16DUXaA
250 or maybe 100 ohms should be plenty. Worst case you can always stack a couple up.
Thank you! Does it work using the same voltage divider circuit that was outlined in the post on crowdsupply? Those look significantly easier to work with in terms of size and location on the board.
