2025-08-05, 07:06 AM
We are planning on fixing some issues with card remounting in firmware which should help with the unable to remount issue. You shouldn't have to reflash the device though, have you tried doing a hard reset to force it to reboot after inserting the card?
We designed the cover to sit slightly inset from the case when properly inserted on the SD card, so you might want to check that it's not sitting proud from the case as that would make it very easy to press accidentally.
The cover is large and pressable by design, we wanted it to be easy to remove without needing any tools, but that does mean it's easier to accidentally bump open. You don't need to use the cover, as it's main reason for being there is to make it easy to remove the SD card and it sounds like in your case this is unwanted. If you want a simple low tech fix, you could just not use the cover and put a sticker over the slot to prevent dust/lint/etc. But if you have access to a 3d printer you could design a plug that fits inside the case where the SD cover would go, with a smaller slot in it to allow for inserting/removing the SD card.
We designed the cover to sit slightly inset from the case when properly inserted on the SD card, so you might want to check that it's not sitting proud from the case as that would make it very easy to press accidentally.
The cover is large and pressable by design, we wanted it to be easy to remove without needing any tools, but that does mean it's easier to accidentally bump open. You don't need to use the cover, as it's main reason for being there is to make it easy to remove the SD card and it sounds like in your case this is unwanted. If you want a simple low tech fix, you could just not use the cover and put a sticker over the slot to prevent dust/lint/etc. But if you have access to a 3d printer you could design a plug that fits inside the case where the SD cover would go, with a smaller slot in it to allow for inserting/removing the SD card.
