2024-03-17, 10:54 AM
the one minute bath is a nice news 
I uses to work in a 3 printing shop that dyed SLS print and the process was a couple of hours long.
I wonder if the dye would creep up the polycarbonate through capilarity... If so, I might try to submerge one corner in ine color then the opposite corner in another color. Another experience would be to tie a nylon cord round the shell and drop the end of the cord in the dye to see if we can dye from the middle.
I uses to work in a 3 printing shop that dyed SLS print and the process was a couple of hours long.I wonder if the dye would creep up the polycarbonate through capilarity... If so, I might try to submerge one corner in ine color then the opposite corner in another color. Another experience would be to tie a nylon cord round the shell and drop the end of the cord in the dye to see if we can dye from the middle.