Yesterday, 12:51 AM
(2025-12-14, 05:29 PM)taivlam Wrote: What 3D printer did for the first batch of Tangarine buttons? (I didn't know the initial batch of buttons were using TPU.)
Prusa mk3. (From back before Prusa went so far off the rails.)
Same printer I'm using today, but now it's been through an additional cross-continent trip in a moving truck, and is now confined to an enclosure. I've not had the brain-cycles to properly troubleshoot it so I've kind of just messed with the settings to trade some print quality for reliability.
I have plans to build a fully-custom FDM printer at some point next year...
