I have Exciting Updates for you all, but first, I need to tell you all I found the screw.
Then I picked it up to take a picture of it.
And immediately dropped it and lost it again.
More evidence for the hypothesis that my life is a bad sitcom.
----
Anyway. I'm closing in on a design I'm happy with, the shipment of 10 displays I ordered a month ago is probably arriving in the near future maybe, and a few people have expressed interest in having one of these if only someone would build them and sell them. I doubt it's worth setting up a whole storefront for this, but I'd be willing to put together a few of them and mail them out to some of y'all.
BOM cost looks like it'll be around US$7 each for electronics, plus whatever it costs to print the plastic bits (in my picture here, the black is ABS and the white is TPU; there are also variants of the TPU part with inset symbols and with plain flat buttons). Would people want to print their own plastic bits or should I print plastic bits?
Then I picked it up to take a picture of it.
And immediately dropped it and lost it again.
More evidence for the hypothesis that my life is a bad sitcom.
----
Anyway. I'm closing in on a design I'm happy with, the shipment of 10 displays I ordered a month ago is probably arriving in the near future maybe, and a few people have expressed interest in having one of these if only someone would build them and sell them. I doubt it's worth setting up a whole storefront for this, but I'd be willing to put together a few of them and mail them out to some of y'all.
BOM cost looks like it'll be around US$7 each for electronics, plus whatever it costs to print the plastic bits (in my picture here, the black is ABS and the white is TPU; there are also variants of the TPU part with inset symbols and with plain flat buttons). Would people want to print their own plastic bits or should I print plastic bits?
