[sbszine]

I've been playing some music on the new Tangara. Sounded great and all going well but now I think it's somehow bricked or stuck in a weird loop. The symptom I'm getting is a white screen. Stuff I have tried:

1. Hard reset with volume buttons and lock switch
2. Flashed latest firmware with Tangara companion (reported success)
3. 'esptool.py run' results were:

esptool.py v4.8.1
Found 1 serial ports
Serial port /dev/cu.usbmodem201
Connecting.....
Detecting chip type... Unsupported detection protocol, switching and trying again...
Connecting......
Detecting chip type... ESP32
Chip is ESP32-D0WD-V3 (revision v3.0)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: 24:4c:ab:10:04:ec
Uploading stub...
Running stub...
Stub running...
Hard resetting via RTS pin...

In all cases the screen goes black, then white, then after a second there are two short vibrations. I think it might actually be working except for the display behaviour.

Any ideas?