[jacqueline]

Hi all!

We have released a new firmware version: https://codeberg.org/cool-tech-zone/tang...tag/v1.1.1

Most notably, we expect much improved SD card compatibility (not over USB mass storage yet). If you've had an SD card that previously didn't work with Tangara, could you please give this release a go and let us know if there's any improvement? Thanks in advance!

Keep on grooving,
Jacqueline

[deshipu]

I just tried it with my card, but no luck.

[1172098.071483] usb 5-4.2: new full-speed USB device number 37 using xhci_hcd
[1172098.295688] usb 5-4.2: New USB device found, idVendor=1209, idProduct=2014, bcdDevice= 1.00
[1172098.295708] usb 5-4.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[1172098.295717] usb 5-4.2: Product: Tangara
[1172098.295723] usb 5-4.2: Manufacturer: cool tech zone
[1172098.295729] usb 5-4.2: SerialNumber: b5c1593831202337
[1172098.312258] cdc_acm 5-4.2:1.0: ttyACM0: USB ACM device
[1172098.312951] usb-storage 5-4.2:1.2: USB Mass Storage device detected
[1172098.313606] scsi host2: usb-storage 5-4.2:1.2
[1172099.320783] scsi 2:0:0:0: Direct-Access    TinyUSB  Mass Storage    1.0  PQ: 0 ANSI: 2
[1172099.321564] sd 2:0:0:0: Attached scsi generic sg3 type 0
[1172099.322247] sd 2:0:0:0: [sdc] 61863936 512-byte logical blocks: (31.7 GB/29.5 GiB)
[1172099.322923] sd 2:0:0:0: [sdc] Write Protect is off
[1172099.322931] sd 2:0:0:0: [sdc] Mode Sense: 03 00 00 00
[1172099.323710] sd 2:0:0:0: [sdc] No Caching mode page found
[1172099.323726] sd 2:0:0:0: [sdc] Assuming drive cache: write through
[1172099.336062]  sdc: sdc1
[1172099.338397] sd 2:0:0:0: [sdc] Attached SCSI removable disk
[1172099.388018] sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_OK driverbyte=DRIVER_OK cmd_age=0s
[1172099.388024] sd 2:0:0:0: [sdc] tag#0 Sense Key : Not Ready [current]
[1172099.388027] sd 2:0:0:0: [sdc] tag#0 Add. Sense: Medium not present
[1172099.388030] sd 2:0:0:0: [sdc] tag#0 CDB: Read(10) 28 00 03 af f7 ff 00 00 01 00
[1172099.388031] blk_update_request: I/O error, dev sdc, sector 61863935 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 0
[1172099.401580] sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_OK driverbyte=DRIVER_OK cmd_age=0s
[1172099.401583] sd 2:0:0:0: [sdc] tag#0 Sense Key : Not Ready [current]
[1172099.401585] sd 2:0:0:0: [sdc] tag#0 Add. Sense: Medium not present
[1172099.401587] sd 2:0:0:0: [sdc] tag#0 CDB: Read(10) 28 00 03 af f7 ff 00 00 01 00
[1172099.401588] blk_update_request: I/O error, dev sdc, sector 61863935 op 0x0:(READ) flags 0x0 phys_seg 1 prio class 0
[1172099.401593] Buffer I/O error on dev sdc, logical block 7732991, async page read
[1172099.478501] sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_OK driverbyte=DRIVER_OK cmd_age=0s
[1172099.478506] sd 2:0:0:0: [sdc] tag#0 Sense Key : Not Ready [current]
[1172099.478508] sd 2:0:0:0: [sdc] tag#0 Add. Sense: Medium not present
[1172099.478510] sd 2:0:0:0: [sdc] tag#0 CDB: Read(10) 28 00 03 af f7 ff 00 00 01 00
[1172099.478511] blk_update_request: I/O error, dev sdc, sector 61863935 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 0
[1172099.491836] sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_OK driverbyte=DRIVER_OK cmd_age=0s
[1172099.491840] sd 2:0:0:0: [sdc] tag#0 Sense Key : Not Ready [current]
[1172099.491842] sd 2:0:0:0: [sdc] tag#0 Add. Sense: Medium not present
[1172099.491844] sd 2:0:0:0: [sdc] tag#0 CDB: Read(10) 28 00 03 af f7 ff 00 00 01 00
[1172099.491845] blk_update_request: I/O error, dev sdc, sector 61863935 op 0x0:(READ) flags 0x0 phys_seg 1 prio class 0
[1172099.491849] Buffer I/O error on dev sdc1, logical block 7732735, async page read

[sethkush]

I can't get it to work with either of the SD cards I have around.

- Kingston CANVAS Go! Plus (1TB): Works sometimes immediately after formatting, but soon begins to boot to garbled video. USB Storage mode is pretty buggy with this one when it does work.
- Lexar 256GB Micro SD Card, microSDXC UHS-II: Just doesn't recognise it at all.

[ailurux]

I can't get it to work with either of the SD cards I have around.

- Kingston CANVAS Go! Plus (1TB): Works sometimes immediately after formatting, but soon begins to boot to garbled video. USB Storage mode is pretty buggy with this one when it does work.
- Lexar 256GB Micro SD Card, microSDXC UHS-II: Just doesn't recognise it at all.

- When you say it boots to garbled video, do you mean the Tangara's display begins acting strangely?

- That's annoying. We've had a similar card not get recognised at all, and the changes in 1.1.1 fixed the issue. Can you confirm that you've formatted the card as FAT32 or exFAT and that you're running the latest firmware on the device?

[sethkush]

I can't get it to work with either of the SD cards I have around.

- Kingston CANVAS Go! Plus (1TB): Works sometimes immediately after formatting, but soon begins to boot to garbled video. USB Storage mode is pretty buggy with this one when it does work.
- Lexar 256GB Micro SD Card, microSDXC UHS-II: Just doesn't recognise it at all.

- When you say it boots to garbled video, do you mean the Tangara's display begins acting strangely?

- That's annoying. We've had a similar card not get recognised at all, and the changes in 1.1.1 fixed the issue. Can you confirm that you've formatted the card as FAT32 or exFAT and that you're running the latest firmware on the device?

Yes to both. FAT32 using mkfs.fat. The display turns to a weird mix of vertical bars static/colours and mostly black, though sometimes white background. The clickwheel sometimes changes things on the garbled display, but sometimes doesn't.